Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 177)

3. Touch the SpHb tab.
4. Specify settings.
Setting Action/Description
Default view Select a numeric view or a trend graph view as the
primary SpHb display on the Home tab.
Unit of measure Select the primary unit of measure for the SpHb display
on the Home tab.
Default averaging Select the default moving window of time used by the
parameter to calculate the SpHb value and update the
display: short (approximately 1 minute), medium
(approximately 3 minutes), or long (approximately 6
minutes).
Reference Select arterial or venous as the calibrated reference
source.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced tabs and return to the Home tab, touch Exit.
Specify advanced NIBP settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the NIBP tab.
4. Specify settings.
Setting Action/Description
Default view Select primary and secondary views.
Select Display MAP to display mean arterial
pressure (MAP) in the NIBP frame on the Home tab.
If Display MAP is selected, specify which numerics
are primary in the NIBP frame. On the Home tab,
clinicians can touch the NIBP frame to toggle between
views.
Unit of measure Select the NIBP unit of measure for display.
Tube type Select the number of tubes that are connected to the
NIBP cuff used with this monitor. If you select 1 tube ,
the only algorithm available for selection is Step .
Algorithm default Select the default algorithm used to determine NIBP
measurements.
Cuff inflation target If you select the Step algorithm, touch and enter
a default cuff inflation target for each type of patient.
Clinicians can change the CITs from the default CITs that
Directions for use Advanced settings 171