Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 173)

Pause Mode timeout Specify the default timeout used when entering Pause
mode in the Continuous Monitoring profile.
Power line frequency Specify power line frequency for AC power supplied to
the device.
Available profiles Specify the profiles to be available for selection.
Allow profile change Select to enable manual selection of different profiles
and the automatic shift to the Continuous Monitoring
profile when a continuous sensor is connected to a
patient.
When disabled, the current profile selection in the
Settings tab is locked in. No other profile selection
buttons are available, and the device does not
automatically shift to the Continuous Monitoring profile
when a continuous sensor is connected to a patient.
Default profile Specify the default profile to be used at startup in the
following Continuous Monitoring profile workflows: 1)
patient trend data has not been saved, and 2) patient
trend data has been saved and the user selects a new
patient.
4. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Set and start the demo mode
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the General tab.
3. Touch the Demo tab.
4. Specify settings.
Setting Action/Description
Type Select a type of demonstration mode.
Start Touch Start to put the monitor in demonstration mode.
Navigate to the Home tab to begin Demo mode.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Demo mode, touch Exit on the Home tab. The monitor restarts
automatically.
Directions for use Advanced settings 167