Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 30)

Note Do not remove the tab label from the battery. This tab helps
you remove the battery from the compartment when you
need to replace it.
5. Replace the battery cover by inserting one end into the notched access and then
pressing firmly on the opposite end.
Note New batteries are only 30 percent charged. Therefore, connect the monitor
to AC power immediately after inserting a new battery.
Mount the monitor
You can install the monitor on a mobile stand or on an interior wall equipped with a
Welch Allyn-approved wall-mount fixture.
Check the mounting bracket
Before you mount the monitor, make sure the stand or wall-mount fixture has the
mounting bracket designed for your monitor. Monitors with a standard housing require a
small bracket. Monitors with an extended housing require a large bracket.
Small bracket for standard housing Large bracket for extended housing
Note If your monitor has an extended housing but the small bracket is installed
on your stand or wall-mount fixture, you must replace the small bracket
with the large bracket. Follow the steps presented in the Mounting Bracket
Replacement Install Guide shipped with the large bracket, and then
proceed to mount the monitor.
24 Setup Welch Allyn Connex ® Vital Signs Monitor 6000 Series™