Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 178)

you set here on the Settings > Setup > NIBP
tab.
Allow interval program changes Select to enable user to modify interval program
selections in the Settings > Setup > Intervals
tab.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify advanced temperature settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab will appear.
2. Touch the Parameters tab.
3. Touch the Temperature tab.
4. Specify settings.
Setting Action/Description
Unit of measure Select primary units of measure for the temperature
display on the Home tab
Display temperature conversion Select this to display primary units of measure and
secondary units of measure for the temperature display
on the Home tab.
Default SureTemp Plus site Select the default site for SureTemp measurements. The
default site applies when clinicians power up the
monitor and each time clinicians remove the temperature
probe from the well.
Select Last site to set the default to the site selected
for the last measurement.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify the manual parameters
The Manual Parameters frame is in the lower right corner of the Home tab. You can
manually enter values for parameters in the frame. In Advanced settings, you can specify
which parameters appear in the frame and enable manual overrides of other parameter
measurements displayed on the device.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
172 Advanced settings Welch Allyn Connex ® Vital Signs Monitor 6000 Series™