Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 179)

d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the Manual tab.
4. Select up to four parameters and associated units of measure for display in the
Manual Parameters frame.
Note If the monitor has the SureTemp Plus temperature module,
the Temperature parameter is not available here or in the
Manual Parameters frame.
Note If the monitor is configured with CO2 or RRa, and you select
the Continuous Monitoring profile before you enter
Advanced settings, the respiration rate (RR) parameter is not
available here or in the Manual Parameters frame. If any
other profile is selected when you enter Advanced settings,
the respiration rate (RR) parameter remains available for
selection on this screen and is displayable in the Manual
parameters frame.
5. Enable manual overrides of selected parameter measurements displayed on the
device as desired.
6. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Data management
Specify patient settings
Patient identification appears on the Home tab in the Patient frame, and it is listed in
various tabs, such as the Patient tab and the Review tab.
1. Access the Advanced Settings.
a. Touch the Settings tab.
Directions for use Advanced settings 173