Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 182)

d. Touch OK.
The General tab appears.
2. Touch the Data Management tab.
3. Touch the Clinical Data tab.
4. Specify settings.
Setting Action/Description
Automatically send on manual save Select this option to specify that measurements are sent
to the network when a clinician saves measurements on
the Home tab.
Note When the device is in the Continuous Monitoring
profile, this setting is grayed out.
Note When the monitor is not connected to the network,
measurements saved on the monitor are sent to the
network with the first successful send after reconnecting
to the network.
Delete readings after successful send Select this option to specify that measurements are
deleted from the monitor after they are successfully sent
to the network. Sent measurements do not appear in the
Review tab.
Emulate Spot Vital Signs LXi Select this option to specify that clinical data sent to the
network appears as Spot Vital Signs LXi data at the
network.
Connect to CS Select to enable connection to the Connex central
station.
5. Do one of the following:
• To continue in Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Network
View advanced monitor information
The Status tab shows the monitor's software version, MAC and IP addresses, network,
server and access point information, session information, and more.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Network tab.
3. Touch the Status tab.
4. View the information.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
176 Advanced settings Welch Allyn Connex ® Vital Signs Monitor 6000 Series™