Banner SC22-3E Safety Controller with Ethernet - Manual (Page 6)

1 About This Document
1.1 Important . . . Read This Before Proceeding!
It is the responsibility of the machine designer, controls engineer, machine builder and/or maintenance electrician to apply and maintain
this product in full compliance with all applicable regulations and standards. The product can provide the required safeguarding function
only if it is properly installed, properly operated, and properly maintained. This manual attempts to provide complete installation, opera-
tional, and maintenance instruction. Reading the manual completely is highly recommended. Please direct any questions regarding the
application or use of the product to the Banner Engineering Applications at the locations listed here.
For more information regarding U.S. and international institutions that provide safeguarding application and safeguarding product per-
formance standards, see the following sections.
WARNING: . . . User Responsibility
The user is responsible to:
• Carefully read, understand and follow the information in all documentation for this product.
• Perform a risk assessment of the specific machine guarding application.
• Determine what safeguarding devices and methods are appropriate per the requirements defined in ISO 13849-1 and
other appropriate standards.
• Create and confirm each configuration and then verify that the entire safeguarding system (including input devices and
output devices) is operational and working as intended.
• Periodically re-verify as needed, that the entire safeguarding system is working as intended.
Failure to follow any of these recommendations can potentially create a dangerous condition that may lead to seri-
ous injury or death.
1.1.1 Use of Warnings
Warnings are intended to remind the machine designer, control engineer, machine builder, maintenance electrician, or end user how to
avoid misapplication of this product and effectively apply the Safety Controller to meet the various safeguarding application requirements.
Reading and abiding by the warnings is highly recommended.
1.2 EC Declaration of Conformity (DOC)
Banner Engineering Corp. herewith declares that the SC22-3 Series Safety Controller is in conformity with the provisons of the Machi-
nery Directive (Directive 98/37/EEC) and all essential health and safety requirements have been met. For more information, visit
www.bannerengineering.com/SC22 .
SC22-3/-3E Safety Controller Instruction Manual
6 www.bannerengineering.com - tel: 763-544-3164 P/N 133487 rev. C