Create a new configuration, Add an input device – Banner SC22-3E Safety Controller with Ethernet User Manual
Page 55
Create a New Configuration
Open the software program, and a new un-named file is created. You may name the Configuration and the Author, and establish the
system settings at this time.
Double-click the System Settings icon
, on the right-hand side of the Tool Bar.
When the pop-up menu appears, name the configuration file, using up to 16 alphanumeric characters.
Add your name in the Author’s name box (up to 10 characters; abbreviate as needed).
Keep or change the default system settings:
• Power up mode: Auto, Manual, or Normal (default), see section
on page 18
• Mute on power up: ON or OFF (default), see section
on page 18
• Monitored system reset: OFF or ON (default), see section
on page 31
When complete, click OK.
Add an Input Device
10 Input Device and Safety Category Reference
on page 90 for more information about each of the input device types.
Click the Add Safety Input icon and the Safety Input Device selection menu appears. It displays the device types the Controller can
accommodate.
Safety Input Devices
Figure 36. Safety Input Device Selection menu
• Emergency stop button
• Rope pull
• Gate (interlock) switch
• Optical sensor (single-/multiple-beam sensors, safety light curtain,
area scanner, etc.)
• Two-hand control device
• Safety mat
• Protective stop (miscellaneous devices)
• Enabling device
• Muting sensors
• Bypass switches
• External device monitoring (EDM or AVM) contacts
Click the Non-Safety Input icon and the Non-Safety Input Device selection menu appears.
Non-Safety Input Devices
Figure 37. Non-Safety Input Device Selection menu
• Manual reset switch
• ON/OFF switch
• Mute enable switch
• Cancel OFF-delay switch
While their functions differ, the procedure to add and configure the two
types of devices is virtually identical. Click on the appropriate icon to se-
lect the desired device and click OK (or double-click on the icon).
SC22-3/-3E Safety Controller Instruction Manual
P/N 133487 rev. C
www.bannerengineering.com - tel: 763-544-3164
55