System reset, 3 revise an existing configuration – Banner SC22-3E Safety Controller with Ethernet User Manual
Page 59
Figure 42. Confirm Configuration screen, all devices confirmed by user (checklist is compressed)
If the columns do not match, or if you wish to change any circuit:
• Select Edit for the device to be changed.
• The Properties menu for the device will open.
• Make the necessary change(s).
• Select OK.
A message will appear asking whether you want to edit any other devices or if you want to restart the confirmation process.If
any device properties are changed while in the manual verification stage of the confirmation, the Controller will pro-
ceed to re-validate the code.
If the columns match, and no changes need to be made:
• Select Confirm for each device.
• The verification screen shows the summary that is created after each property has been verified.
• If you need to review a confirmed device property, un-check the checkbox and the Device Properties window will reappear.
Edits may then be performed, as necessary.
6. When you are through with the manual verification, click OK.
7. When the verification process is complete, the Confirm Configuration summary screen is displayed. Select Close and perform a
system reset; see section
8. The Controller will activate the new configuration and will function according to the new parameters.
System Reset
The Controller requires a system reset under certain conditions:
• To place the Controller into Run mode after it has been configured.
• To recover from certain conditions (e.g., lockouts).
To perform a system reset, either provide a 24V dc signal on the System Reset input (located next to the Status Output O10 terminal), or
cycle power.
When the configuration is successfully confirmed, the Controller will switch to Run mode.
5.1.3 Revise an Existing Configuration
When the software program opens, go to File > Open or click the
icon to browse for the configuration to be changed. Make
changes as described in section
on page 54.
SC22-3/-3E Safety Controller Instruction Manual
P/N 133487 rev. C
www.bannerengineering.com - tel: 763-544-3164
59