Banner Mechanical E-Stop Buttons - Manual

Datasheet
Figure 1. SSA-EBM-xxE Series
with Enclosure
Figure 2. SSA-EBP-xxE Series
with Enclosure
• Push-to-stop, twist-to-release operation
• Rugged, modular design; easy assembly and
installation
• Kits available for easy selection
• Choice of metal or plastic button base with or without
enclosure; all kits include disc label with “Emergency
Stop” legend
• Choice of normally closed (safety) or combination
normally closed/normally open (non safety) contacts
• Latching design complies with ISO 13850; direct
(positive) opening operation per IEC 60947-5-1
Models
Button Base
Material
Contacts
Enclosure
Included
SSA-EBM-02L
Metal
2 normally closed
No
SSA-EBM-11L
1 normally closed and 1
normally open
SSA-EBM-12L
2 normally closed and 1
normally open
SSA-EBP-02L
Plastic
2 normally closed
SSA-EBP-11L
1 normally closed and 1
normally open
SSA-EBP-12L
2 normally closed and 1
normally open
SSA-EBM-02E
Metal
2 normally closed
Yes
SSA-EBM-11E
1 normally closed and 1
normally open
SSA-EBM-12E
2 normally closed and 1
normally open
SSA-EBP-02E
Plastic
2 normally closed
SSA-EBP-11E
1 normally closed and 1
normally open
SSA-EBP-12E
2 normally closed and 1
normally open
WARNING: Not a Safeguarding Device
An Emergency Stop Device is not considered a safeguarding device because it requires an
overt action by an individual to stop machine motion or hazards.
A safeguarding device limits or eliminates an individual's exposure to a hazard without action by the
individual or others. Because an individual must actuate the device for it to function, these devices do
not fit the definition of a safeguarding device and cannot be substituted for required safeguarding. Refer
to the relevant standards to determine those requirements.
SSA-EB Series Emergency Stop Buttons
Original Document
111880 Rev. A
12 February 2014
111880