Banner DUO-TOUCH Run Bar with STB Buttons - Manual

Datasheet
U.S. Patent(s) issued or pending
• Continuous internal self-checking operation
• Diverse-redundant microcontroller-based photoelectric touch
buttons
• Ergonomically designed to eliminate hand, wrist and arm
stresses associated with repeated switch operation; require no
physical pressure to operate
• High excess gain cuts through heavy contamination
• Immune to ambient light, EMI and RFI interference
• LED power, output and fault indicators
• Yellow field cover included
Model Cable
Supply
Voltage
Output Type
DUO-TOUCH ® SG
Compatibility
STBVP6
4-wire 2 m (6.5 ft) integral
cable
10–30V dc
Complementary
PNP
AT-FM-10K, AT-GM/HM-13A, and
AT-GM/HM-11KM Two-Hand
Control Modules, and SC22-3
Safety Controller
STBVP6Q 4-Pin Mini-style QD
STBVP6Q5 4-Pin Euro-style QD
STBVR81
5-wire 2 m (6.5 ft) integral
cable
20–30V ac/dc
Two Individual
Complementary
Relays
STBVR81Q 5-Pin Mini-style QD
STBVR81Q6 5-Pin Euro-style QD
Standard 2 m (6.5 ft) cable models are listed. To order the 9 m (30 ft) cable model, add suffix "W/30" to the cabled model
number. For example, STBVP6 W/30. Models with a QD connector require a mating cable.
WARNING:
Not a Stand-Alone Safety Device. STB Series Touch Buttons are self-checking ergonomic actuating
devices, but are not, by themselves, safety devices. To be used in a safety application, two STBs must
be interfaced with a type IIIC two-hand-control module, such as the Banner AT-FM-10K, to meet all
relevant safety requirements of the appropriate standards (e.g., ISO13851 / EN574).
Important - Read This Before Proceeding
The user is responsible for satisfying all local, state, and national laws, rules, codes, and regulations relating to
the use of this product and its application. Banner Engineering Corp. has made every effort to provide complete
application, installation, operation, and maintenance instructions. Please direct any questions regarding the use or
installation of this product to the factory applications department at the telephone numbers or address found at http://
www.bannerengineering.com .
The user is responsible for making sure that all machine operators, maintenance personnel, electricians, and
supervisors are thoroughly familiar with and understand all instructions regarding the installation, maintenance, and use of
this product, and with the machinery it controls. The user and any personnel involved with the installation and use of this
product must be thoroughly familiar with all applicable standards, some of which are listed within the specifications.
Banner Engineering Corp. makes no claim regarding a specific recommendation of any organization, the accuracy or
effectiveness of any information provided, or the appropriateness of the provided information for a specific application.
Applicable U.S. Standards
ANSI B11 Standards for Machine Tools Safety
STB Self-Checking Optical Touch Buttons
P/N 64136 Rev. C 4 December 2013