Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual - Manual (Page 50)

50 Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 4 Set Up Your EtherNet/IP Network
Configure a Driver for the Network
1. Start RSLinx software.
For the RSLinx software to locate new devices on the EtherNet/IP
network, the driver can be set up (browse the remote subnet option) to
look for a specific IP address and mask.
2. Click Configure Driver.
3. From the Available Driver Types pull-down menu, choose the driver for
your network.
4. Configure the driver.
The settings you make are dependent upon the network you choose and
whether you are using a communication card or interface module.
Make Sure the Driver Works
1. Check the Configure Drivers dialog box to make sure that the driver is
running.
2. Close the dialog box.
3. Open the RSWho dialog box.
4. Double-click the driver to see the network.
Connecting the SmartGuard
600 Controller to the
EtherNet/IP Network
Network Driver
RS-232 RS-232 DF1 devices
EtherNet/IP Ethernet devices
DeviceNet DeviceNet driver
USB SmartGuard USB Driver
TIP You can configure the driver by using the Remote Subnet selection and
by setting the IP address and mask to the value of the SmartGuard
controller. This lets RSLinx software quickly find the device.
IMPORTANT The SmartGuard controllers must not be directly connected to any network
that is not protected from outside intrusion. For example, do not connect the
SmartGuard 600 controller to an Ethernet network that is not protected with a
firewall or other security measures.