Save the program, Update the program, Save the program update the program – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual User Manual
Page 150
150
Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 10
Create Your Application Program
3.
Connect the jump address to the function block.
4.
Select the page to which you want to connect the logic.
5.
Right-click anywhere on the page and choose Select JumpAddress.
6.
Select the jump address from the pull-down menu.
7.
Connect the jump address to the function block.
Save the Program
Follow these steps to save your application program.
1.
Choose File>Apply.
The program is saved temporarily in RSNetWorx for DeviceNet software.
2.
Exit the Logic Editor by choosing File>Exit.
3.
Click OK or Apply on the Edit Device Parameters dialog box.
If you do not click OK or Apply or you click Cancel, none of your program
changes are saved. Any programming saved temporarily by using
File>Apply is deleted.
4.
Choose Save or Save As from the RSNetWorx for DeviceNet software
main dialog box.
Update the Program
If the I/O tags of safety slaves that configure the SmartGuard controller’s local I/
O are changed, you must start the Logic Editor and check the program.
If you load the parameters to the controller without starting the Logic Editor, a
download error occurs in the Logic Editor because of data inconsistency. If this