D - function blocks command reference, Introduction, Reset function block – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual User Manual
Page 217: Appendix d, Function blocks command reference, Introduction reset function block, Appendix
Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
217
Appendix
D
Function Blocks Command Reference
Introduction
This appendix describes the function blocks used for programming.
Reset Function Block
Figure 44 - Reset Function Block Diagram
The number of inputs can be increased from two to eight on the I/O Settings tab
of the Function Block Properties dialog box in RSNetWorx for DeviceNet
software. The default number of inputs is two.
Topic
Page
Light Curtain (LC) Function Block
Safety Gate Monitoring Function Block
Two-hand Control Function Block
OFF-delay Timer Function Block
User Mode Switch Function Block
External Device Monitoring (EDM)
Reset
Reset
Optional Input 1
Monitored Input
Output Enable
Monitored
Input
Output Enable
Static Release
Reset Required
Indication
Optional Input 2
Optional Input 3
Optional Input 4
Optional Input 5
Optional Input 6
Static Release
Reset Required
Indication
Default Connections
Maximum Inputs for Reset Function