Add a function block, Connect the tags to the function block – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual User Manual
Page 145
Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
145
Create Your Application Program
Chapter 10
2.
Select the tag you want to use, and drag and drop it into position on the
workspace.
You can select multiple I/O tags and position them at the same time.
Figure 33 - Place Input Tags
Add a Function Block
Follow these steps to add a function block to the workspace.
1.
Click the Function Block tab in the object list.
2.
Select the function block you want to use, and drag and drop it into
position on the workspace.
Figure 34 - Place a Function Block
Connect the Tags to the Function Block
To connect the I/O tags to the function block, click the source connector (
?
) and
drag it to the destination connector (
?
).
TIP
Input and output tags that are used in the application program appear
bolded in the object list.