Lenze PLC Designer V2.x - Manual (Page 41)

1.3 EN - 07/2012
L
41
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8400 StateLine - "LAS_40_INTF_Can_84SL_Speed" sample project
8.1 8400 StateLine - "LAS_40_INTF_Can_84SL_Speed" sample project
Further information on the function libraries used in this project can be found in
the following section:
The L_S84_Drive8400.lib library
( 235)
Standard procedure

How to commission the controller:
1. Commission 8400 Stateline. Commissioning
( 42)
2. Load the project "LAS_40_INTF_Can_84SL_Speed.zip" to the controller using the L-
force »Engineer«. Open the »Engineer« project & go online
( 43)
3. Open the "LAS_40_INTF_Can_84SL_Speed.pro" sample project in the »PLC
Designer«. Program structure in the »PLC Designer«
( 45)
4. Load the project to the IPC/EL 1xx and go online.
8.1.1 Components used
[8-1] System configuration with EL x800 CAN master (ID=0, connection at CAN1) and 8400 StateLine (CAN node ID=5)
Industrial PC Field device
Hardware EL x800 8400 StateLine
Operating system IPC software from version Logic
7.02.x (release 2.2.x)
From firmware V5.1
Lenze software required »PLC Designer« from version 20.3
L-force »Engineer« from version 2.12
Further requirements • CAN master ID = 0
• Connection to interface CAN 1
• Logic CAN 500kB
• CAN node ID = 5
• Motor: SDSGAI056-22