Lenze PLC Designer V2.x - Manual (Page 204)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9300 - "LAS_40_INTF_Can_93_EP" sample project
204
L
1.3 EN - 07/2012
8.8.5.5 Homing mode
 Button  selects the homing mode.
Note!
• The homing is only to be carried out once after initial switch-on.
• The reference can not be reset.
• Program set number 3 in manual mode activates the reference setting.
– As a standard setting, homing mode 0 is active in the controller (travel over ref-mark
/ DigIn 4 in positive direction with H-L edge negative to home position)
 Button  starts the homing.
 Button  stops homing.
 Button sets the home position.
– Set direct reference / Pos Act = 0 unit
 Dialog box  shows the homing status.
 Dialog box  signalises whether the homing has been completed successfully.
– After a successful homing, the display field is coloured in green.
 Dialog box  shows the current homing mode (code value).
 Select mode  Stop button  Reset position
 Start button  Set position  Mode status