Lenze PLC Designer V2.x - Manual (Page 149)

1.3 EN - 07/2012
L
149
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8200 vector - "LAS_40_INTF_Can_82_Speed" sample project
8.6.2 Short overview of the functions
8.6.2.1 Commissioning

How to commission the 8200 vector:
1. Connect the 8200 vector and the Engineering PC to the PC system bus adapter
(EMF2177).
2. Switch on voltage supply.
8.6.3 Open the »Global Drive Control« project & go online

How to open the sample project in the »Global Drive Control«:
1. Start »Global Drive Control«
Use F2 to call the dialog window Connect with drive.
• Search for controller (F2):
• The 8200 vector is identified at the CAN bus and the applicable device
description is loaded.
Tip!
Mode Description
Automatic In the automatic mode a sequence runs over an infinite loop.
Selection:
• Travel for three seconds at speed1,
• then for five seconds at speed2,
• Start with speed1 again.
Manual In manual mode, the controller can be actuated by setting the individual
control bits manually (Jog1, Jog2, QSP, ErrorReset...). Like this, the controller
can be actuated in manual mode, for instance for cleaning or changing the
tools.
Service The service mode serves to adjust the controller.
Selection:
• Travel in positive direction for one second,
• Stop for one second,
• Travel in negative direction for one second.

Read the mounting instructions supplied with the controller first before you start
working!
The mounting instructions contain safety instructions which must be observed!

Detailed infomation on the general handling of »Global Drive Control« can be
found in the online help for the »Global Drive Control«, which you can call with
[F1].