Lenze PLC Designer V2.x - Manual (Page 165)

1.3 EN - 07/2012
L
165
PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
8200 vector - "LAS_40_INTF_Can_82_Speed" sample project
8.6.6 Interface assignment in the »Global Drive Control«
[8-32] Assignment of digital inputs DIGIN E1 - E4
[8-33] Assignment of the digital outputs: DIGOUT 1 - digital output A1/A2
[8-34] Assignment of CAN IN1: CAN/FIF-IN1 input block 1
 Terminal 28 (CInh) is to be assigned on
24 V DC.
 The assignment of further digital
inputs is not required.
 Digital output A1 is HIGH active.
 The following bits of wCtrl are
assigned and connected to the NSET
block or the DCTRL (Drive Control):
bCtrl_B00 = xJog1
bCtrl_B01 = xJog2
bCtrl_B02 = xCCw
bCtrl_B03 = xQSP
bCtrl_B04 = not used
bCtrl_B05 = not used
bCtrl_B06 = not used
bCtrl_B07 = not used
bCtrl_B08 = free
bCtrl_B09 = xEnable
bCtrl_B10 = xErrorSet
bCtrl_B11 = xErrorReset
bCtrl_B12 = free
bCtrl_B13 = free
bCtrl_B14 = free
bCtrl_B15 = free