Lenze PLC Designer V2.x - Manual (Page 190)

PLC Designer V2.x| Lenze Application Samples
Working with the sample projects
9300 - "LAS_40_INTF_Can_93_EP" sample project
190
L
1.3 EN - 07/2012
8.8.3 Open the »Global Drive Control« project & go online

How to open the sample project in the »Global Drive Control«:
1. Start »Global Drive Control«
• Search for controller (F2):
Use F2 to call the Connect with drive dialog box:
2. The 9300 EP is identified at the CAN bus and the applicable device description is
loaded.
Tip!
Further information on the setting parameters of the CAN bus can be found in the
dialog window Selection of communication driver (menu command
OptionCommunication).

Detailed infomation on the general handling of »Global Drive Control« can be
found in the online help for the »Global Drive Control«, which you can call with
[F1].