Lenze PLC Designer V2.x - Manual (Page 34)

PLC Designer V2.x| Lenze Application Samples
Commissioning a sample project
Wiring the hardware
34
L
1.3 EN - 07/2012
7.2 Wiring the hardware
Before you can work with the project, the hardware has to be connected to each other. The
sample projects are configured so that the motors rotate if a controller is used as CAN
node.
 Connect the desired IPC (Industrial PC to PLC, or an EL1xx to a PLC) with the CAN nodes.
 Connect the devices (Industrial PC, controllers, motors) with the corresponding voltage
supply
 Connect the components with a CAN bus cable.
– For this, use the CAN1 interface in the case of the Industrial PC. The CAN2 interface
is not required for the sample project.
– In the case of the EL100 there only is one CAN interface to be connected with the
components.

Further information on the electrical connections can be found in the
documentation supplied. Please read the mounting instructions supplied with
the controller first before you start working!
The mounting instructions contain safety instructions which must be observed!