2N NetStar Admin manual - Manual (Page 71)

71
that arrive in the PBX with the subtype. The other subtypes are Unknown
retained. Normalising takes place as defined in the menu. Localisation
Replace always – all incoming numbers are normalised.
Retain– no number is normalised. The numbers are further processed with
the subtype they arrive in the PBX with.
AutoClip routers
This section is used for assigning a selected AutoClip router to a virtual port. Assign the
AutoClip routers for calls and messages separately but you can use one and the same
AutoClip router. For details on AutoClip routers refer to Chapter
. 7.7 AutoClip Routers
Calls – here you can assign an AutoClip router for saving records on outgoing
calls. To make the function work, assign the
to the calling AutoClip parameters
user in the menu on the user or use group level. To Routing – Users & groups
assign the use the AutoClip parameters Global data – Autoclip parameters
menu.
Messages – here you can assign an AutoClip router for saving records on
outgoing SMS. To make the function work, assign the
to AutoClip parameters
the calling user in the menu on the user or use Routing – Users & groups
group level. To assign the use the AutoClip parameters Global data –
menu. One and the same AutoClip router can be used Autoclip parameters
both for SMS and calls.
Cause mapping
In this section, you can specify your own sets of causes to be used for signalling. To do
this, use the
menu. You can set a Global data – Causes – Cause mapping tables
translation of a certain event into the given interface (SIP, GSM a ISDN) in the cause
mapping table. Use these sets only if the predefined cause translations are
inconvenient.
CP to stack – define a specific cause translation for changes from the PBX to the
virtual port. Hence, it is a change of a specific internal cause into any stack
cause.
Stack to CP – define a specific cause translation for changes from the virtual
port to the PBX. Hence, it is a change of any stack cause into a specific internal
cause.
You can choose a mapping table for each direction, the use of a table assigned disable
to a virtual port type or use to enable the default table. Default
Name information sending
The parameters included in this section are intended primarily for the SIP Gateway
virtual port. Depending on the selection of one of the two parameters below,
information on the calling line can be inserted in the From field of the SIP INVITE
message.
Find name in group phone book – select a group in the telephone directory for