2N NetStar Admin manual - Manual (Page 175)

175
Advanced settings
Send CLIP – this is a table facilitating incoming call identification. Having passed
the table, the call Id is modified as required. The Send as parameter helps you
set two identification display modes. Select Display to display the Number/URI
as the CLIP on the telephone, but the original CLIP will be stored in the CPN
history. Select Force to modify both the CLIP displayed during ringing and the
CLIP stored in the CPN history. Use Scheme to select either number or URI and
Type to set the number subtype (Unknown, Internal, Local, National or
International).
Force facility – refers to the called number. It is used in DSS1 messages for
communication with Ericsson exchanges for billing purposes. Again, set the
(Number or URI), (Unknown, Internal, Local, National, Scheme Subtype
International) and (specific number or address). Number/URI
Force forwarding – refers to the called number. It is used in DSS1 messages
for communication with Nokia exchanges for billing purposes. Again, set the
(Number or URI), (Unknown, Internal, Local, National, Scheme Subtype
International) and (specific number or address). Number/URI
Assistant – use this section to set the selected ring group with respect to the
Assistant user application.
Visible in Assistant – use this option to display a ring group within the
application. If it is not checked, the ring group is not available for use.
Group – use this option to set a group of users to be able to work with the
selected ring group within the application. Assign ring groups to so–called
root groups only (never to subgroups). The assigned ring group is available
to all the root group and subgroup users.
Accounting group – use this option to enable adding the required group
number into the accouting sentence for a selected object for later cost
distribution purposes.