2N NetStar Admin manual - Manual (Page 171)

171
Alerting strategy
This strategy represents a new DISA concept. When a call comes to the port, it is
immediately routed to the preset Alerting destination and this destination is being
alerted till the end of timeout. The timeout is set by the
parameter. The call Timeout
is not answered during the timeout and the calling user hears the alert tone from the
network. After the timeout, the call is answered, but only towards the calling user, who
is played the predefined progress tone. The Alerting destination is still being alerted. If
the DTMF option is checked, the DTMF detector is connected after the timeout and
remains active until the end of routing (answer, reject, etc.). The DTMF digits are
transferred into the router selected in the
option. Destination after DTMF dial
Figure: Příklad konfigurace objektu DISA se strategií Vyzváněcí
The menu consists of the following parameters:
Alerting destinace – set the alerting destination parameters.
Type – set the destination type for call routing.
Id – choose a destination of the selected type.
Timeout [s] – set the timeout for playing the predefined voice message.
The '0' selection is not suitable for the
strategy since the call Alerting
would be answered immediately, which is undesirable in this strategy.
Tone – select a tone from the current list of PBX progress tones.
Destination after DTMF dial – set a router for call routing by the PBX after
DTMF dialling.
DTMF – define whether or not the DTMF detector shall be allocated for this
DISA object.
Type – set the router type for call routing.