2N NetStar Admin manual - Manual (Page 118)

118
Destination for addresses
Use this parameter to define the routing destination if the address specified in the
Conference subscribers block is used for conference call set–up. If the Default
destination type is selected and the calling party is an address, you cannot call the
specified addresses but can call the extensions and users that are dialled directly. If the
calling party is a extension or user, you can call the addresses too (routing From port
of the calling party is used).
Type – define the destination type for the address.
Id – define the specific destination of the selected type.
Parties to conference
In this configuration section, you can specify users, extensions or just telephone
numbers including properties for a conference room. For this purpose, seven columns
with the following meanings are available:
Destination type – here select a user, extension or address. The following
columns are available or not depending on your selection.
Destination – here define a extension or user.
Schema – here enter the Number or URI scheme for the address.
Prefix – select the required prefix from the list of prefixes defined in the Global
data – Global parameters menu for the address. Use this prefix for dialling the
given conference subscriber.
Number/URI – enter a specific Number of URI for the address.
Dials others – here set whether the selected user has the right to call a
conference for the selected conference room.
Is dialled – here set whether the selected user shall be dialled or not during
conference set–up.
Active users
This tag includes an on–line list of all active conference participants. The extension
name (if available in the telephone directory), scheme (Number/URI), number type
(national, internal, ...) and the number are defined here for each of them.