2N NetStar Admin manual - Manual (Page 242)

242
Delete oldest after reaching limit – enable deleting of oldest record files if
necessary.
2N TELEKOMUNIKACE, a.s. shall not be held liable for any recording
errors due to unavailable network disks and/or exceeding of the
maximum storage capacity.
Customer
The Customer subtag provides parameters for functions that have been implemented
for a specific customer and so their meanings will be explained marginally only. This
subtag is divided into three sections. Define the supported method of the CPN sending
for call billing purposes in the first section. Set the called party identification to be
transmitted via a DSS1 message in the remaining parts.
Forwarding number – is used in DSS1 messages for communication with
exchanges for billing purposes. Set the (Number or URI), Nokia Scheme
(Unknown, Internal, Local, National, International) and Subtype Number/URI
(specific number or address).
Facility – is used in DSS1 messages for communication with Ericsson
exchanges for billing purposes. Set the
(Number or URI), Scheme Subtype
(Unknown, Internal, Local, National, International) and (specific Number/URI
number or address).
The number for call billing is sent using this information element. Make sure that the
parameter is set for the virtual port too. Choose
, or . Yes, No Default
In addition to DSS1, the parameter is also used in SIP signalling, where it sets the
header. Diversion