2N Wireless 3G router 2N EasyRoute_new design - Quick start, 1664 v1.00 - Manual

Incoming Call
1. An incoming call is signalled by ringing.
The phone line LED is flashing during
ringing.
2. Hook off the phone to establish the
call. The phone line LED is permanently
on during the call.
3. Hang up the phone to terminate the
call.
Internet Setup
· Login
1. Make sure that the TCP/IP protocol is
installed in your PC and set the PC to
getting IP address automatically from
the DHCP server. Most operating
systems use this setting by default.
2. Open any web browser: Internet
Explorer, Mozilla Firefox, Google
Chrome, etc.
3. In the address window, write the IP
address: 192.168.1.1 to get into the
basic login dialogue.
4. Log in as Administrator. Fill in the fields
as follows.
User: Admin Password: 2n
You can also use
User: admin , Password: admin
for older 2N® EasyRoute versions.
· GSM/UMTS setup
Use the Wizard menu to set a quick
Internet connection (short form
setting). Be sure to confirm any change
in the Wizard submenus using the
Apply button in the right-hand bottom
corner.
5. If you use a PIN protected SIM card,
set the PIN in the WIZARD->SIM
menu. Then enable the Remember
item to make the gateway use this PIN
after restart.
6. Use the WIZARD->Internet menu to
set the Internet connection
parameters. These parameters are set
automatically
by most Internet
providers. Check the APN [list] for
your provider. If your provider is not
included, fill in the APN and Dial items
using information obtained from your
Internet provider. For some providers,
it is necessary to fill in the User and
Password fields too.
7. Use the WIZARD->Wireless menu to
enable the WiFi connection in your local
network (Enable). Use encoding to
protect your LAN against unauthorised
access if necessary. You are suggested
to use the WPA or a higher encoding
system to get the proper level of
protection.
8. Check the current state of the router in
the STATUS menu where the most
important information is displayed. The
Status field displays the Internet
status: Connected. Now you can start
browsing through the Internet.
9. In this menu you can check such
gateway parameters as the connection
type, provider, signal strength and
some more parameters important for
the gateway function.
10. For more advanced settings and rules
such as SIP connection, Firewall and
many others refer to the CD manual.
11. Use the LOG OUT button in the left
bottom corner to leave the
configuration interface. Logout is done
automatically after 20 minutes of
inactivity.
In the GSM network, data transfers are suspended during voice calls and
do not continue until the voice call is finished, whereas in the 3G (UMTS)
network data and voice are transferred simultaneously.
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N
® EasyRoute product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our website
www.2n.cz for the Declaration of conformity.
© 2011, 2N TELEKOMUNIKACE a.s. – Prague, LH 1664, v.1.00