2N NetStar Admin manual - Manual (Page 234)

234
including these parameters.
No port – use this option to set routing rules for the extensions that are not
assigned to any port. Such extensions include, in particular, PBX external or
virtual port extensions used for special routing cases.
For call routing by the PBX refer to the
chapter. Routers
Parameters of unsuccessful sending
Repeat at fail – use this option to enable repeating of a failed SMS sending
attempt. An attempt may fail due to a GSM network rejection or bad signal
quality. This option does not refer to SMS delivery failures due to switch–off or
temporary unavailability of a remote GSM extension.
Number of repeated attempts – use this parameter to set the maximum count
of sending attempts at an SMS sending failure due to network rejection or
temporary signal unavailability. The default value is 4000.
Time for message repeat [s] – use this parameter to set the interval between
successive SMS sending attempts. The default value is 180s.
ME
The ME subtag is used for setting parameters for external extensions. They mostly
include parameters for call holding using an external extension. Mobile phones are not
equipped with a standard PBX call holding key and that is why this function has to be
replaced with a sequence of DTMF symbols. This tag contains the following parameters:
Transfer – use this parameter to enable call holding from an external extension.
This function is subject to licence and hierarchy. If you define this parameter on
the user level, you need as many licences as many extensions the user has (the
external extension is not included because it needs licence for use).
Pattern time interval [ms] – use this parameter to set the time interval
between individual characters of the FLASH and DISCONNECT patterns. This time
interval is important for a correct recognition of the pattern. If the delay between
the pattern characters is longer than the preset time value, the pattern will not
be recognised.
FLASH pattern – use this parameter to set the sequence of the FLASH pattern
characters used for call holding. Re–enter the FLASH pattern to reconnect a held
call or switch between two calls (one active and one on hold).
DISCONNECT pattern – use this parameter to set the sequence of the
DISCONNECT pattern characters. When you have one active call and one call on
hold, use this pattern to terminate the active call and reconnect the call on hold.
Do not end outgoing call – use this parameter to select that an outgoing call
from the PBX to an external station shall not be terminated after the calling
subscriber hangs up. Instead, the user gets the busy tone from the PBX and can,
using the DISCONNECT PATTERN, return to the dialtone and dial the required
station through the PBX. The selection is disabled by default.
Do not end incoming call – use this parameter to select that an incoming call
from an external station to the PBX shall not be terminated after the calling
subscriber hangs up or the DISA fails. Instead, the user gets the busy tone from
the PBX and can, using the DISCONNECT PATTERN, return to the dialtone and
dial the required station through the PBX. The selection is disabled by default.
Forwarding
The whole tag is available on the group and user levels only.
This subtag is used for call forwarding setups. The unconditional call forwarding (CFU)
has the highest priority. The other two forwarding types have the same priority and