2N NetStar Admin manual - Manual (Page 52)

52
Signal diagnostics
Signal measuring – select this option to enable signal level measuring for a
selected carrier.
Signal monitoring – here enable signal level monitoring for a selected carrier. If
the signal level drops below the value specified in the Poor signal level
parameter, a red exclamation mark appears on the port in the
Hardware –
menu and a red text is displayed in the upper stack status field. This Boards
poor signal status gets changed after the signal level exceeds the value specified
in the
parameter. The interval between the values represents Good signal level
hysteresis.
Figure: View of GSM Virtual Port Hardware Configuration