2N Fixed line replacement with 2N EasyGate PRO UMTS - Quick Start, 2018 v1.00 User Manual

Outgoing call, Incoming call, Configuration over usb

Outgoing call

· Suppose that the SIM card has been

inserted, the PIN entered or not required,
and EasyGate is registered to the network

– the LED Mobile network is permanently
on.

· Hook off the telephone, you can hear the

dial tone and the Line LED starts flashing.

· Dial the subscriber number. EasyGate

receives tone dialing (DTMF) by default.

If your telephone transmits pulse dialing
only, program EasyGate to receive pulse

dialing. When you make a delay in your
dialing longer than 5s (programmable),

the connection is established.

· If the called subscriber is available, you

can hear the ringing tone. If not, you can
hear the busy tone or any of the mobile

network provider’s messages.

· When the called subscriber answers the

call, the call is established. The Line LED
is permanently on during the call.

· Hang up to terminate the call. The Line

LED goes off. If the called subscriber is

the first to hang up, you can hear the
busy tone, you have to hang up.

Incoming call

· An incoming call is signaled by ringing.

The Line LED flashes during ringing.

· Hook off the phone to establish the call.

The Line LED is permanently on during
the call.

· For call termination see the Outgoing call

section.

Configuration over USB

· For PC configuration of EasyGate is

necessary to install PCManager UNI.
Connect EasyGate to PC using USB cable.

· Virtual serial port(USB serial port FTDI) is

created immediately after linking PC and

EasyGate. This port is used by
PCManager

communicate

with

EasyGate. When the port isn’t activated
automatically use driver on CD

· The COM port number of virtual serial

port has to be set in PCManager.

· Detailed description is in the product

manual on CD-ROM.

Data connection over USB

· Easy Gate can be used for high speed

connection to internet (up to 3,6 Mbps

download).

· You have to install USB drivers for UMTS

module. Drivers are on CD-ROM. You
have to select 32 bit drivers or 64 bit

drivers according to your system.

· For internet connection you must set the

APN. Use PCManager, select GSM&SIM
menu and set APN to the APN name of

your mobile internet provider.

· You have to set phone connection in your

PC using Network connection setting.
Select modem ‘SimTech HS-USB Modem

9000’ for this connection. Set the
connection

parameters

(Username,

Password, Dial number) according to
information from your mobile provider

(obviously Username ‘internet’, Keyword
is empty an Dial number *99***1#).

· Finally use button ‘Dial’ to establish

connection to internet.

In the GSM network data transfer is suspended during voice calls and do
not continue until the voice call is finished. UMTS network is able to

transfer data concurently with voice.

EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyGate PRO UMTS product is in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our
website www.2n.cz for the Declaration of conformity.