2N NetStar Admin manual - Manual (Page 191)

191
Figure: View of Binary I/O - Detector Configuration Menu
Messages for events
Sending events - displays the current state of event sending. If such
sending is enabled, the messages can be sent and the
button is Enable
inactive. If the sending is stopped, the messages are not sent and the
button is ready for use. Enable
Active detector state - use this option to enable a message about the
active state of the detector. Within this section you can define the message
text to be sent. Optionally, you can stop sending after this message by
selecting the
option. Stop sending when message was sent
Inactive detector state - use this option to enable a message about the
inactive state of the detector. Within this section you can also define the
message text to be sent. Optionally, you can stop sending after this
message by selecting the
option. Stop sending when message was sent
Detector unavailable - use this option to enable a message about an
unavailable detector. Within this section you can also define the message
text to be sent. Optionally, you can stop sending after this message by
selecting the
option. Stop sending when message was sent
Detector ready - use this option to enable a message about a ready
detector. Within this section you can also define the message text to be
sent. Optionally, you can stop sending after this message by selecting the
option. Stop sending when message was sent