Time condition, Advanced settings, Default identification – 2N NetStar Admin manual User Manual
Page 199: Example
199
Time condition
You can set a time condition in the last identification table column to define the validity
time for each row. If the time condition is valid, the particular identification table row
can be applied. If not, the row is ignored. This helps identify users and/or virtual ports
differently for different parts of the day, week or month. You can assign the time
conditions created in the
Advanced settings
You can define advanced parameters for each identification table row – Numbering
,
and
– to be transmitted via DSS1 signalling. In
plan
Screening
Presentation
addition, you can disable the advanced
and
functions, which are
Facility
Forwarding
used in some networks.
Numbering plan – use this column to set the used numbering plan for each
table row.
Screening – use this column to set the screening information for each table row.
Presentation – use this column to set the CLI presentation restrictions for each
table row.
Disable facility – use this option to disable
for a selected identification
Facility
table row.
Disable forwarding – use this option to disable
for a selected
Forwarding
identification table row.
Default identification
The lower menu is called
and helps you set identification parameters for all the
Default
calling parties that have not been found in the table. The functions of these parameters
are the same as those of the yellow–highlighted parameters as described earlier.
Consider forwarded user
– use this option to enable the use of the identification
table for a changed CLI in the event of call forwarding. Refer to the example below for
more details.
Example
Suppose a call is coming to user B from user A. User B's calls are forwarded outside the
PBX via the port to which the identification table with the
Consider forwarded user p
arameter enabled is assigned. The identification table has records for both user A and
user B, and, in this case, the record assigned to user B is used. If the above mentioned
parameter were disabled, the record assigned to user A would be used.