2N NetStar Admin manual - Manual (Page 190)

190
Detector Setup
Detector status - this parameter displays the current status of the detector
(Active, Inactive, Unknown). With the
option, the assigned binary port Unknown
is probably configured as an output or the port or board is unavailable
Tone connected - sets the tone to be played to the calling user when the
detector gets in the active state upon pick up. The playing mode depends on the
and parameters. Timeout Play whole tone
Tone disconnected - sets the tone to be played to the calling user whenever
the detector gets in the inactive state upon pick up. The playing mode depends
on the
and parameters. Timeout Play whole tone
Tone events enabled - sets the tone to be played to the calling user when the
is checked. The playing mode depends on the and Send events Timeout Play
parameters. whole tone
Timeout - use this parameter to set the call duration. After the time limit, the
call is hung up (unless the following option is checked).
Play whole tone - use this option to enable playing the whole tone
independently of the preset time limit.
Send events - use this option to enable SMS sending for predefined events.
Send as user - use this parameter to define a user as an SMS sender. Be sure
to select the SMS routing parameters for the SMS sender.
Destination for events - use this section to define the destination for sending
the detector status messages. Select a user, extension or number. SMS
messages to users and extensions are routed directly but those routed to an
address use the From port of user routing as set in the Send as user parameter.