2N NetStar Admin manual - Manual (Page 17)

17
1.5 PBX Activation
What you need
To activate and configure you need the , a 2N NetStar
®
2N NetStar
®
system
computer running the supported Windows version, a keyboard and a mouse. The PC
and PBX have to be interconnected in a LAN. Furthermore, it is 2N NetStar
®
necessary to display the redirected standard PBX input and output on your PC console.
To do this, you need a six–wire, crossed cable with a six-pin RJ-12 connector on one
end and a serial connector on the other. This cable is supplied as standard equipment.
You can use a 'Tera Term Pro' console or any other functional console. You can also
work in the HyperTerminal mode, but longer lines are interlaced.
Step 1: IP address setting
Prior to starting configuration you need to set up the PBX IP address to establish
network communication between the system and the computer. To do this, you can use
a serial console or the default IP address 192.168.100.100. The – PC 2N NetStar
®
communication can be on-line or off-line. To configure the console use the table below.
Speed 115200
Bits 8
Parity None
Stop bits 1
Flow control None
If necessary, a serial port or modem may be used for PBX connection through the
configuration tool, yet at a considerably lower bit rate.