2N NetStar Admin manual - Manual (Page 245)

245
Destinations/Time conditions
You can add a destination and time condition to each credit in this section. Destination
means the target network to be dialled.
Context menu options:
Add – add a destination.
Rename – rename the selected destinaci.
Delete – remove the selected destinaci.
Tariff setting – Here you can set or change the time condition for the selected
destination.
Tariff description
Context menu options:
Add – add a row to the destination describing table.
Delete – remove the selected description table row.
Column description:
Note – for information only.
Minimum charged time [s] – set the minimum call cost. If a call is answered,
these seconds are charged to the calling subscriber regardless of the duration of
the call. Typically, this value is set to 60s.
Charge to [s] – set the call billing interval after the Minimum charged time
elapses.
Valid to [s] – set the end of the interval to which a row applies. For example, if
you set 360s, the row will be used for the first 6 minutes only and then the next
row will be applied. If you set , the row is valid without limitation.
0
Tariffication impulse time [s] – use the parameter to set the sending
frequency for the tariffication pulses for DDS1-supporting devices. By default, the
tariffication pulses are not sent - the parameter value is zero.
Arrows next to the window are used for modifying the row sequence.
Prefix list
Here you can manage the prefixes that relate to the selected destination and credit. If
one of these prefixes is dialled via a specific virtual port and the time condition is met,
the rules for this credit are used for billing.
Context menu options:
Add – add a row to the prefix table. Matching prefixes are highlighted.
Delete – remove the selected prefix table row.
Column description:
Prefix – this item shows the prefixes that are assigned to the selected credit
destination. If * is included, the rule applies to all prefixes.