2N NetStar Admin manual - Manual (Page 238)

238
The outgoing calls are not limited in the Do not disturb mode.
ESC – push the Escape key to reject incoming calls, return to a superior level or
clear a character in an item.
FLASH – push the Flash key to hold calls. If a call is on hold, you can dial
another user or service number. Re–push the key to switch between two calls
(one active and the other on hold).
STATE– use the State button to set speed dialling for the selected number and
monitor the state of the selected virtual port, user or extension at the same. The
user state displays all user extensions. The state is indicated by a LED at the
button:
INTERCOM – push the
key to interconnect two StarPoint key phones. Intercom
All you have to do is enter the CPN in the dialogue box. After you push the key,
the connection is established automatically. The called user needs a HandsFree
key phone for this function.
"Quit" – the LED is off if all the user extensions are at relax (the selected
extension or virtual port is at relax).
"Hook off" – the LED is on if one of the user extensions at least is
off–hook (the selected extension or virtual port is off–hook).
"Is alerted" – the LED is flashing if one of the user extensions at least is
ringing (the selected extension or virtual port is ringing).
PHONE DIRECTORY – use this option to display the phone directory. This key
has the same function as the right arrow.
MUTE – push the
key to temporarily deactivate your key phone Mute
microphone. Push the key again to re–activate it.
REDIAL – push the Redial key to dial the last–dialled number.
HANDSFREE – push the
button to switch a call from the HandPhone HandsFree
to the HandsFree mode and back for the StarPoint key phones only. The
HandsFree mode uses a microphone and loudspeaker placed on the terminal
body.
MISSED CALLS – use this function to enter the
menu. Missed calls
DIALED CALLS – use this function to enter the menu. Dialled calls
ANSWERED CALLS – use this function to enter the menu. Received calls
NO FUNCTION – this option has no function and ignores any fall down from
lower–priority levels.
NEW MESSAGES – use this function to enter the
. Received messages menu
PROFILES – use this function to enter the menu for profile Profiles
activation/deactivation.
ACTIVATE PROFILE – use this function to directly activate or deactivate a
selected profile. The option is not available until the user profile has been
created.
CALL SLOT – use the button as a slot for another call on the selected extension.
The count of the call slots is limited by the Maximum hold level parameter in
the Properties - Basic tag. Push this button during a call to hold the call, the
held subscriber hears the dialling tone and can route the call to another
extension. If the Queue parameter is enabled in the Properties - Basic tag, the
call slots are occupied by incoming calls. Thus, you can switch the callers, putting
the inactive call on hold during which the caller hears the Hold tone.
CALL RECORDING – push the button to start recording the current call. Repush
the button to stop recording. Refer to the
Recording . subtag for call recording
details.