2N NetStar Admin manual - Manual (Page 275)

275
1.
Set the and tags for this port. When you are in the Stack Virtual port Stack
menu, set the interface mode to NT and mode to PTP.
To apply your new configuration, save the changes to NetStar using the saving icon (or
Ctrl+S). To configure the interface into the TE mode, take the same steps and set the
jumpers and interface mode to TE.
LCR Creation
The final configuration step is to create the LCR rules and configure the interfaces to
work properly according to these rules.
Our task is to enable all outgoing calls to be passed to GSM and all incoming calls to
play the DISA welcome note or be passed to the PBX IVR.
Outbound calls
We need to take three steps for outbound calls.
Create a GSM bundle responsible for a correct and well-balanced use of all GSM