2N NetStar Admin manual - Manual (Page 10)

10
Figure: View of Possible PBX Connection Structuret
To change the PBX connection settings use the . Properties icon
PBX properties
The dialogue shown in figure below helps you create a PBX or change the properties of
an existing PBX. The parameter meanings are as follows:
Name – define the name of the PBX to be connected.
Folder – use this parameter to define the path to the folder for the configuration
to be saved.
Autosave – use this option to enable automatic database saving in the off-line
mode.
Autosave database after – here set the interval for automatic database
backup. This function may only be used for the off-line mode.
Delete autosave item older than – here set the maximum time for keeping old
database backups in the storage folder. This function can only be used in the
off-line mode.
Autosynchronisation – If this selection is active, the tool tries to synchronise
the data automatically with the PBX without inquiring. This function can only be
used in the off-line mode. If this selection is active, 'Loading from PBX' is
performed if the off-line database is empty. 'Display changes' is performed if the
database has been synchronised, the identifier matches and 'Database from
Autosave' has not been selected. Otherwise, the synchronisation type dialogue is
invoked. If this selection is inactive, the dialogue is invoked in all cases.