2N NetStar Admin manual - Manual (Page 181)

181
Modems
Modem Connection
Modem connection is used for remote PBX access where no TCP/IP connection is
available. A modem also provides remote access to the database and enables to
receive current system traces via the TraceView application. Modem access, however,
is considerably limited by a low data rate and thus is not recommended for the
Localisation where the TCP/IP access can be used. The current NetStar PBX firmware
version supports the
. The figure below shows an ISDN modem with protocol X.75
example of modem configuration for remote access to the PBX.
Figure: View of PBX Remote Access Modem Configuration
Connection Setting
To enable modem connection, select the required modem from the list of devices (if
unavailable in the list, the modem is probably not installed in the PC) in the Properties
and select the number to be dialled for PBX connection. This number must then be
routed to the routing object created in the Routing - Routing objects – Modems me
nu.