2N Door camera for 2N Helios - Installation manual - camera 9135210E - Manual

2ENTRY Helios color video camera kit
Order No. 9135210E
Description
The 2ENTRY Helios color video camera kit contains all necessary items for additional
upgrade of your door communicator. It contains an electronic camera module, movable hinge
and the connection cable for the camera and the communicator’s main board. The video
camera is adjustable both vertically and horizontally due to the movable hinge system. In order
to configure the camera use the appropriate connectors (jumpers) provided in the kit.
!!Warning!!
The video camera shares the power supply with the back light. Before installation make sure
that the parameters of the back light power supply comply with the requirement of the video
camera (see “Technical Parameters” section in the manual). The suitable power supply is
12V/2A stabilized. It is possible to order this power supply by using order number 91341481E.
In no case use AC power supply (mains transformer)!
Installation
1. Remove metal cover from the door phone.
Remove plastic cover from the base by
unscrewing the screws (4x) located at the
corners.
2. Remove the black camera cover and replace it
with the clear cover from the “video kit”.
3. Remove the loudspeaker cradle from the base
by lifting out the pins and pushing the cradle
slightly forward.
4. Assemble the movable hinge and screw (2x) it
to the base. Place the video camera on the top
of the hinge and use provided screws (2x) to
secure (see the figure below).