2N NetStar Admin manual - Manual (Page 54)

54
GSM modul diagnostic
Producer – provides information on the board manufacturer.
Type – provides information on the board type.
Firmware revision – the software revision of the firmware uploaded into the
board.
Module IMEI – shows the detected IMEI code.
GSM network diagnostic
State – shows the current port state for detection of network login problems if
any. For example,
means that the SIM card requires the PIN PIN REQUESTED
code to log in. To log in successfully, you either enter the PIN or disable PIN
requesting by the SIM card.
Net type – displays the type of the network to which the module is currently
logged in.
Logged network – shows the international code of the network to which the
SIM card is logged at the moment.
Network name – shows the name of the network into which the SIM card is
logged at the moment.
Area code – shows the code of the area to which the SIM card is currently
logged in.
Cell ID – shows the ID of the cell to which the SIM card is currently logged in.
Cell selection state – displays information on whether or not the given module
supports manual cell selection.
Signal shows the current signal level (if activated). A low signal level may
–
result in logout or call failure due to a high error rate.
SIM number shows the SIM card code detected.
–
SMS centre number fill in this parameter to enable SMS sending. In GSM –
networks, SMSs are not routed directly to the final destination, but through the
provider's SMS centre. This is useful where an SMS cannot be delivered
immediately (e.g. due to target phone unavailability). The SMS centre tries to
deliver this message cyclically for a preset SMS validity time. This parameter is
mostly automatically detected on the SIM card (preset by the provider). If not,
fill it in manually.
PIN here enter the PIN code if it is required by the SIM card and has not been
–
entered in the SIM SIM cards – cards menu for this SIM card.
PUK here enter the PUK code if it is required by the SIM card and has not been –
entered in the SIM SIM cards – cards menu for this SIM card.
Phone number this field is for information only. You can enter your SIM card –
telephone number for easier orientation. This parameter has no function.