2N NetStar Admin manual - Manual (Page 233)

233
Incoming hold CLIP – use this parameter to forward the called party number to
the called user in the case of call transfer made by the extension where this
parameter is being enabled. It means that, if
is selected, the transferred call YES
will be identified by the CLI of the transferred user ( ) instead of that of the user A
who transferred it ( ). The default value of this parameter is . B NO
Outgoing hold CLIP – use this parameter to display the original calling party
number in the case of call transfer. It means that, if
is selected, you will see YES
the calling party number of the transferred user ( ) instead of that of the user A
who transferred the call ( ). The default value of this parameter is . B NO
Use Replace in identification table – use this parameter to replace a part of
the preset identification (as specified in the identification table) with your own
calling extension identification. The default value of this parameter is YES
(replacement enabled).
CLIR– use this parameter to restrict the calling line identification. Use a service
or a pre–programmed StarPoint phone button to change the station settings. The
parameter is set to NO by default.
Language – use this option to select the language to be used by the StarPoint
terminals. Choose one of the languages listed. The default value corresponds to
the preset
of the PBX. Localisation
Max phone directory item count – use this parameter to set the maximum
count of records in a user private phone directory. This parameter is available on
the user level only! The default value of this parameter is 10 records.
Routing
To port – use this option to route an outgoing call through the selected port.
Outgoing means the outward direction from the PBX.
From port
– the section includes two types of call routing.
Normal – define routing of the calls that arrive in the PBX via the port.
For services and calls on hold – set the routing destination for calls on
hold or services without a destination of its own. This helps you easily
create a complete routing system for PBX external stations.
AutoClip parameters for calls – use this option to choose an AutoClip
parameter set for storing of AutoClip router records. This option can be
used on the user profile, user and group levels only.
No port – use this option to set routing for extensions not assigned to a virtual
port. It is primarily used for the external, email and virtual port extensions that
are used for special routing cases. This setting is available on the virtual port and
virtual port type levels only.
For more information on call and SMS routing refer to Chapter . Routers
Message routing
The tag is available on all hierarchical levels. Its structure is similar Message routing
to that of the Call routing tag but includes several additional parameters.
To port – use this option to set routing rules for the messages that go out of the
PBX through the port.
From port – use this option to set routing rules for the messages that come into
the PBX through the port.
AutoClip parameters for messages – use this parameter to assign a set of
AutoClip parameters as defined in the
Global data – AutoClip parameters
menu. All records on outgoing SMS messages are stored in the AutoClip router