2N Fixed line replacement with 2N EasyGate PRO - Quick Start, 1711 v1.01 User Manual

Outgoing call, Incoming call, Fax and data connection (only fax models)

Outgoing call

· Suppose that the SIM card has been

inserted, the PIN entered or not required,
and EasyGate is registered to GSM

network – the GSM Network LED is
permanently on.

· Hook off the telephone, you can hear the

dial tone and the Line LED starts flashing.

· Dial the GSM subscriber number.

EasyGate receives tone dialing (DTMF) by

default. If your telephone transmits pulse
dialing only, program EasyGate to receive

pulse dialing. When you make a delay in
your

dialing

longer

than

(programmable),

the

connection

established.

· If the called subscriber is available, you

can hear the ringing tone. If not, you can

hear the busy tone or any of the GSM
provider’s messages.

· When the called subscriber answers the

call, the call is established. The Line LED

is permanently on during the call.

· Hang up to terminate the call. The Line

LED goes off. If the called subscriber is
the first to hang up, you can hear the

busy tone and hang up.

Incoming call

· An incoming call is signaled by ringing.

The Line LED flashes during ringing.

· Hook off the phone to establish the call.

The Line LED is permanently on during

the call.

· For call termination see the Outgoing call

section.

Fax and data connection

(only fax models)

EasyGate with fax converter has ability to
manage fax messages using analogue fax
Group 3 and data connection using analog

modem connected to telephone line. The
fax or data service must be registered with

your GSM operator.

· Outgoing FAX call or Data connection

Before destination number dial code

*01* for fax call or *02* for data call.
When connected device generates calling

tone, this preset is not necessary.

· Incoming FAX call or data connection

It is recommended to activate separate

fax number on your SIM card –
multinumbering

scheme.

Fax

messages and data connection should be
routed to appropriate number.

If the fax or data number is not
activated, the call from analogue network

is not detected as fax or data call and is
routed via the analogue channel of GSM

network, the connection can´t be
established. In this case it is possible to

set fax engine in the gateway to receive
the next call as fax or data call. This

setting can be done permanent - see the
manual on CD-ROM. This function is not

guaranteed by all operators.

Configuration over USB

· For PC configuration of EasyGate is

necessary to install PCManager UNI.
Connect EasyGate to PC using USB cable.

· Virtual serial port(USB serial port FTDI) is

created immediately after linking PC and

EasyGate. This port is used by
PCManager

communicate

with

EasyGate. When the port isn’t activated

automatically use driver on CD

· The COM port number of virtual serial

port has to be set in PCManager.

· Detailed description is in the product

manual on CD-ROM.

In the GSM network, GPRS data transfer is suspended during voice calls
and do not continue until the voice call is finished.

EC Declaration of Conformity

Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyGate PRO product is in compliance with the

essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our

website www.2n.cz for the Declaration of conformity.