2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 95)

Autoclip routers 7.4
95
Default identification
The last field is on the bottom of the menu and it is used for identification setting of all calling parties,
which weren't found within the tab. Function of parameters within this part is same as by parameters
from yellow highlighted part, which were described before.
7.4 Autoclip routers
Autoclip router
The autoclip routers are used for automatic routing of incoming calls and SMS messages in the case,
that specific record is found within assigned autoclip router. Records are added into autoclip routers
when outgoing calls or SMS messages go through carriers, to which are autoclip routers assigned. For
record adding in the case of SMS message you need only to send it. In the case of outgoing call, that
call have to be rejected or not accepted by called party. For easier understanding you can use
examples on the end of this chapter.
Use of autoclip router
The autoclip routers you can set up in the menu Routing – Autoclip routers . This menu is divided
into two parts. On the left side of the menu is displayed list of the created autoclip routers. Via
context menu you can autoclip routers add, delete or rename. You can also add default autoclip
router. On the right side of the menu is displayed selected autoclip router. You can see there last 100
records and you can also set up few parameters.
The autoclip routers you can assign to the carrier or to the carrier type on the tab Basic. You have to
assign separately autoclip router for calls and autoclip router for SMS messages. In both cases you
can assign same autoclip router or you can assign only one of them. Each record (row) of autoclip
router has flag, which defines if it is record about outgoing call or about SMS message. Each record is
stored with set of parameters. Part of these parameters depends on call (called party number and
subtype, calling user) and another part depends on autoclip parameters set, which is assigned to the
calling user. Mentioned autoclip parameters sets are created within the menu Global data –
Autoclip parameters and you have to assign them separately for outgoing calls and for SMS
messages (you can also use same autoclip parameters sets for both). Autoclip parameters sets for
outgoing calls are assigned within the tab Properties on the tab Routing on the level of user or
group. Autoclip parameters sets for outgoing SMS messages are assigned within the tab Messages
on the level of user or group. If these autoclip parameters sets aren't assigned for some user
(or his group), his records can't be added into the autoclip router!
a) Autoclip router setting
Within the selected autoclip router you can set up four parameters:
Figure 1 View of basic settings of identification tab.
Strategy – This option defines way of handling with records in the case, that more users were calling