2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 67)

Assistant 6.10
67
Autoclip parameters
Into the autoclip table you can save outgoing calls (outgoing messages) records with parameters
dependent on the calling (sending) user. To this purpose serve just autoclip parameters. You can
define it in the menu Global data – Autoclip parameters . This menu is divided into two parts. On
the left side is displayed list of created sets of autoclip parameters. There you can add, remove or
rename sets of autoclip parameters via context menu. On the right side of the menu you can
configure parameters of the selected set of autoclip parameters.
Figure 1 View of the menu for setup of autoclip parameters, which are used for saving autoclip
records.
Name – Name of autoclip parameters set.
Number – Number of autoclip parameters set. It has no function in current firmware, but it is
prepared for future use.
Record is marked as used:
After alerting – Record is marked as used after beginning of the ringing on the originally calling user
(message Alerting).
After active – Record is marked as used after receiving of the incoming call by the originally calling
user (message Active).
Action after record using:
Restart timeout – If this option is checked, is for this record restarted timeout after each use.
Delete record – If this option is checked, is this record removed after use. Both of these options
can't be checked at once, but they can be both unchecked. In this case isn't record removed after
use, but after timeout is it useless.
Timeout [s] – This parameter sets retention time for each record of the autoclip router. When it is
checked, is given record valid infinitely.
6.10 Assistant
6.10.1 Administration setting
The Assistant is web application for user account supervision. Web server for this application can be
run from PbX or from the external computer. Version of web server have to be same as version of
firmware in the PbX. In the menu Assistant you can find three submenu for set up of work with
Assistant and for easy active sessions monitoring.
In the menu
Assistant – Administration setting you can find application basic settings.
Confirm remove – With this option you can enable confirmation of records removing within the call