2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 62)

Ring tones 6.7
62
Other sections
Sections Information about progress and Progress configuration are common for all tabs and
meaning of theirs parameters is described in part Progress list.
6.7 Ring tones
Ring tones you can set up in the menu Tones & Rings - Ring patterns . Each ring tone consists of
ring pattern and cornet melody. Some terminals aren't able to change ring melody and use only ring
pattern. On the left side of the menu is displayed list of the created ring patterns. Via the context
menu you can add new ring patterns or remove them. During creation of the new database is this
menu filled with default progress patterns which you can use, edit or remove as you want. If you
want to restore default setting of some tone patterns, you have to remove them and subsequently
use the option Default from the context menu. Only removed default tone patterns will be restored.
The ring patterns are created via following parameters:
Figure 1 View of configuration menu for ring tones.
Repeat – If this option is checked, adjusted tone pattern will be played repeatedly. If this option isn't
checked, tone pattern is used only once.
Cornet melody – This parameter sets ring tone melody for the system phones StarPoint. Defined