2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 48)

Services Setting 5.2
48
MIB files
Add – With this option you can add MIB files used MIB database extension.
Delete – With this option you can delete selected MIB file.
Recompile – With this option you can recompile selected MIB file.
File – In this column is shown path to the source of MIB file. This path is important for using option
Recompile.
State – This column shows actual state of MIB file. You can see here states Compiled, Not
compiled and Not found. States of MIB files are also indicated by icons on the beginning of each
row as you can see on the figure 2.
Additional information – This column is used for displaying additional information.
Figure 2 View of the section for MIB files management.
Meaning of Notification filter options according to RFC3415
• Internet access:
• subtree 1.3.6.1
• Restricted access:
• System – subtree 1.3.6.1.2.1.1 according to RFC3918
• SNMP – subtree 1.3.6.1.2.1.11 according to RFC3918
• snmpEngine – subtree 1.3.6.1.6.3.10.2.1 according to RFC3411
• snmpMPDStats – subtree 1.3.6.1.6.3.11.2.1 according to RFC3412
• usmStats – subtree 1.3.6.1.6.3.15.1.1 according to RFC3414
When you choose filter Internet, after PbX restart you will receive following traps:
1) ColdStart (PbX announced that it was restarted or switched off)
2) Then is sent information about all ports in stave "L1 active". It means active ports Cornet, BRI and
PRI.
3) Another information is about all CO and ASL ports.
4) Then come information about logging of GSM ports with SIM cards.
5) After it are sent only information about error states and theirs elimination: DSS1 deactivation or
higher BER or SLIP (according to setting), Cornet deactivation (according to setting), ASL – error, CO
– error, GSM – logout or bad signal (according to setting).
Answer
In this tag specify the ports and the client from which the PBX is able to receive requests.
Peer port – On this port PbX expects SNMP requests and acknowledgements. Default port for SNMP
is 161.
From this client address only – With this option you can lock receiving from specific address.