2N PBX 2N NetStar - Configuration Manual v2.6.0 - Manual (Page 49)

Services Setting 5.2
49
Figure 3 View of the part for setting of listening port.
Notification
Client address – It defines IP address or domain name of client, where are sent notifications
according to the below specified filter.
Client port – It defines client port where are sent notifications.
Used local port – If you need you can also specified port of the PbX which is used for sending
notifications.
Notification type – Within this section you can select type of used notification. For SNMP v1 you can
choose only Traps. In other cases are available also inform requests.
Trap – SNMP message sent to the client in the case of some event, which has to be notified. This
message doesn't support any acknowledgement.
Inform request – SNMP message sent to the client in the case of some event, which has to be
notified. This messages have against traps advantage, that all send messages can be resent when
doesn't come any acknowledgement.
Repeat – It defines count of attempts for sending concrete notification.
In interval – It defines time interval in which is expected confirmation about notification reception
from the client.
Version – In this section you can specify way of notification coding according to used version of
SNMP.
SNMP v1
SNMP v2c
SNMP v3