Ag Leader EZ-Guide 500 Getting Started Guide - Manual (Page 82)

Saving the system configuration
Select Configuration / Data Management / Save/Load Configurations / Save Current Configuration. 1.
Select one of the following: 2.
Save to internal memory − Save the current configuration to the lightbar internal memory.
♦
Save to USB drive − Save the current configuration to a USB flash drive.
♦
An existing configuration − Saves the current configuration over the existing one. A warning
message appears. Press
to proceed, or press the function button to exit without saving.
♦
Loading a system configuration
Select Configuration / Data Management / Save/Load Configurations / Load a Configuration. The Load a
Configuration screen appears. 1.
Select the configuration to load from the list and then press . 2.
A message appears to warn that you will load the configuration over the current configuration. Press
to proceed, or press the function button to exit without loading.
Summary Report
The lightbar can produce multi−page field summaries that contain a field map and report.
These summaries are in RTF format and can be viewed on an office computer. The summary report is
automatically created when you close the field. (A field is closed when you run the New Field Wizard). The
summary report has the same name as the field.
Note: To view the graphics in the files, you may need to install the Microsoft® Word viewer utility from the
EZ−Guide 500 Documentation CD.
The summary shows the current implement width. If you create a summary of a field that was driven with an
implement of a different width, change the current implement width to match that of the field before you
78