Ag Leader EZ-Guide 500 Getting Started Guide - Manual (Page 13)

Installation
Step 1: Installing the Lightbar Mount
Select a place in the cab for the lightbar. There must be a mounting bar available for attaching the RAM
mount. 1.
Sit in the driver's seat and hold the lightbar in the place that you selected, make sure that you can access it
comfortably from there. 2.
Step 2: Installing the Antenna
Note: To minimize any interference to the GPS signal, make sure that the GPS antenna is at least 1 m (3 ft) from
any other antenna (including a radio antenna). You may experience interference if you operate the vehicle within
100 m (300 ft) of any power line, radar dish, or cell phone tower.
Installing the Z+ high accuracy antenna
Find the mounting location for the antenna at the front of the vehicle roof.
Screw the antenna mag mount onto the antenna. 1.
On the mounting plate, remove the protective covers from the adhesive strips. 2.
Attach the mounting plate to the vehicle roof with the adhesive strips. Ensure that the mounting plate is
centered along the vehicle roof. 3.
Connect the antenna cable to the antenna. 4.
Place the mag mount (with antenna) directly onto the mounting plate of the vehicle. 5.
Route the other end of the antenna cable into the cab. 6.
Installing the Ag 15 antenna
Find the mounting location for the antenna at the front of the vehicle roof, centered from left to right.
On the mounting plate, remove the protective covers from the adhesive strips. 1.
Attach the mounting plate to the vehicle roof with the adhesive strips. Ensure that the mounting plate is
centered along the vehicle roof. 2.
Connect the antenna cable to the antenna. 3.
Place the antenna directly on the mounting plate. The three magnets embedded in the bottom of the
antenna will hold it in place. 4.
Route the other end of the antenna cable into the cab. 5.
Step 3. Attaching the Lightbar Cables
The lightbar with the basic antenna and power configuration:
9